User`s guide

3-40

(15) BACK ADJUST VAL

Set the back adjust value of media. This value is

used to correct the splice of two images divided by

the auto-cleaning (PH CLEANING [DURING PRINT]

performed during printing.

#BACK ADJUST VAL

>XX:+0000PULSE

XX: Selected media number

±2000 pulses (Unit: Approx. 3.5 μm)

(16) PH REST PERIOD

Scanning of the print head rests at every certain

print length during printing. Set this time period to

prevent nozzle-out of the print head. Normally, set

it to [0000CYCLES].

#PH REST PERIOD

>XX:0000CYCLES

XX: Selected media number

Set the number of scans for print length in [(16) PH REST PERIOD].–

0000 to 9999 Setting [0] does not perform the scan rest.

(17) PH REST TIME

Corresponding to [(16) PH REST PERIOD], set the

scan rest time. When [0] is set for [(16) PH REST

PERIOD], this parameter is ignored. Set this rest

time to prevent nozzle-out of the print head. Set it

to [10 sec] as a rule of thumb.

#PH REST TIME

>XX:10sec

XX: Selected media number

1 to 99 seconds

Set the rest time in [(17) PH REST TIME].–