User`s guide

3-35
3
Menu of operation panel

Explanation of each menu operation
(4) EDGE GUARD
Select whether to use the media edge guard or
not. With this setting, the right and left margins of
media vary.
#USE EDGE GUARD
>XX:YES
XX: Selected media number
<Parameter (choice input)>
YES Set when the edge guard is used.
NO Set when the edge guard is not used.
When the edge guard is used, the right and left margins of print are 10 mm. When it is
not used, the right and left margins are 5 mm.
–
(5) MEDIA ADV MODE
Select a media advance mode.
#MEDIA ADV MODE
>XX:FWD ONLY
XX: Selected media number
<Parameter (choice input)>
FWD ONLY Media is fed in the normal media advance sequence.
BACK & FWD1 Media is fed in the media adhesion prevention sequence. At the beginning
of printing, media peeling is performed during feeding when the pause
mode is cancelled.
BACK & FWD2 Media is fed in the media adhesion prevention sequence. Media peeling is
performed during feeding at each scan.
(6) MEDIA BACK MODE
Select a media back mode.
#MEDIA BACK MODE
>XX:BACK & FWD
XX: Selected media number
<Parameter (choice input)>
BACK & FWD Media is rewound after the print.
Select this mode in most cases.
FWD ONLY Media is not rewound after the print.
When the media is exible such as mesh media, the rewound media may
cause the media wrinkle. To prevent such a wrinkle, select this mode.
In this mode, a blank space is secured between the prints. To eliminate the
space, print the image les as one continuous image data, for example with
the tiling function of SoftRIP.