User`s guide

2-117
2
Basic operation

Periodic maintenance
<Cleaning the madia edge guard>
Note
Perform the procedure below withe gloves on.–
1
Open the front cover.
2
Dip a cleaning swab in the
cap cleaning liquid. Checking
visually, scrub stains on the
media edge guard.
3
Clean the stains with a soft and
clean cloth.
4
Close the front cover.
<Performing normal cleaning>
Select PH.REC MENU from the operation panel, and select NORMAL ALL for cleaning.
<Performing nozzle print>
Select ADJUST MENU from the operation panel, and select TEST PRINTS to perform the
nozzle print.
Check for nozzle-out and incorrect print. The nozzle print is also used to check the print
head before the rst print everyday or after the head is moved out of the capping unit for
cap cleaning. If nozzle-out is found in the nozzle print, perform the normal cleaning.
Note
Do not leave the print head outside the capping unit. Finish the nozzle print
within ve minutes and cap the print head. After the nozzle print is completed,
perform normal cleaning for the print head.
–