User`s guide

2-92
Print out the edge sensor adjustment pattern, and correct the edge sensor position.
After printing, measure the distance and specify the parameter.
1
Hold down the
MENU
key until
the [ADJUST] menu appears.

PRINTER SETUP


ADJUST HEATER

2
Press the key to enter the
[ADJUST] menu.
#TEST PRINTS
>NOZZLE PRINT
3
Press the key.
4
Hold down the key until the
[CHECK EDGE SENSOR] menu
appears.
#TEST PRINTS
>CHECK EDGE SENSOR
5
Press the key.
#TEST PRINTS
*OK?
6
Press the key.
#TEST PRINTS
*EXECUTING
7
Judge the printing results.
Measure the margin of the printing result
with a square, and obtain an difference
between the measured margin and the
value (15 mm) shown in the speci cations.
If the difference is 15 mm, complate this
procedure.
If not, follow the prcedure below to correct
the value.
508 nozzles
(Blank by the even
number of heads)
508 nozzles
(All nozzles)
15 mm
Correcting the edge sensor position