user manual

3
BASIC OPERATION
44
English
3
BASIC OPERATION
45
English
※In the manual time adjustment, the precise time of the currently set time zone is displayed.
When the region or time zone where the watch is used is changed, adjust the time zone.
→ How to adjust the time zone
P.40
(If the time zone is adjusted, the time zone setting, time and date will be adjusted, so it is not necessary to
manually adjust the time immediately thereafter.)
※
Daylight Saving Time (DST) is not automatically set. Carry out the setting manually
→ Set Daylight Saving Time (DST)
P.41
※Failure or success of reception depends on the reception environment.
→ Place where GPS signals can be easily received/Place where GPS signals cannot be received
P.38
※ At the time when the reception was successful by manually adjusting the time, automatic time adjustment may
be performed. For details, refer to “Automatic time adjustment
P.46＜When it is diffi cult to exposure to light ＞
※GPS signal reception consumes a lot of energy.
Keep in mind to charge the watch regularly by expose to light so that the indicator hand points to the “level
position (middle)” or “F (full).”
(When the charging status becomes “E (low),” the reception will not start even with operation of GPS radio
signal reception.) → Check the charging status
P.36
The watch can be set to the precise current time of the currently set time zone.
(The time zone is not changed.)
→ How to manually adjust the time P.45
→Check the time zone setting P.40
Manual time adjustment (To set only the time)
Manual time adjustment
Press
for
3 sec
When the second hand has
reached the 0-sec position,
reception is started.
The indicator hand points to
“1.”
※ While the indicator hand points
to “E” or
, reception is not
started even with operation for
reception.
When the hand points to “E,”
charge the watch by expose
to light.
When the hand points to
,
reset the in-fl ight mode（
）
How to manually adjust the time
Continue to press Button B (3 sec),
and then release it when the second
hand moves to the 0-sec position.
1342
Move to the
outdoors under
an open sky with
good visibility
where GPS
signals can be
easily received.
Direct the watch face
upward and wait
It takes up to
1 min to complete
reception.
※ The reception time
depends on the
reception conditions.
<Display during reception>
The second hand indicates
ease of receiving (= number of
GPS satellites from which GPS
signals are received).
※ To acquire only time information,
the number of satellites necessary
for reception is one.
Press
※ To cancel the reception, press
Button A.
Number of
acquired
satellites
１０
Display
BP
C
J
J
Y
B
P
C
JJ
Y
State
Easy to
receive
Cannot
receive
When the second hand
points to “Y” or “N,”
reception is completed.
The reception result is displayed
for 5 seconds.
Then, the hour and minute hands
move, and the time and date are
adjusted.
Reception
result
display
Y:
Successful
N:
Failed
Display
B
P
C
J
JY
B
P
C
J
J
Y
Check that the reception is
successful after the watch
returns to the time display
mode.
When the time is not correct
even if “Y” is displayed, the
time zone may not correspond
to the region where you are.
→ Check the time zone setting.
P.40