User's Manual
battery status; .
Fig 1
7 8
SELECT Key
Use this key to edit the parameters in operation mode. Keep pressing this key for a
few seconds, the unit will enter into the mute mode, repeat for unmute.
3
4
Mini 4P connector
This connector is used to connect the unit with the clip microphones, for example, HM-38
or HM-58 condenser microphones.
3
1
4
2
Pin 2, GND
Pin 4, for Dynamic or condenser microphone
Antenna
It is the flexible antenna. To get effective transmission, never cover the antenna with
hand, clothes, etc. during the operation, and always position the transmitter nearby the
receiver.
8
Charge Jack
5
Battery Compartment
This unit may be powered from one pair dry or rechargeable batteries, UM3 size AA 1.5V.
6
Belt clip
It is the detachable belt clip for easy carry during the live applications.
7
Pin 3, Phantom power supply for Condenser microphone
Pin 1, for Guitar, bass and keyboards
With the rechargeable batteries put inside, use the charger (optional accessory, provided
by the manufacturer) to recharge the batteries. For the detail operation, please refer to
chapter 4.2.3, Battery replacing and charging.
- Make the right connections first
- Turn on the transmitter
- Turn on the receiver
4. OPERATION
4.1 For the UL-82DR, PLL UHF Diversity Receiver
Battery Compartment
The unit will be powered from a dry or rechargeable battery.
Charge Jack
Connect the optional recharger(see fig) with this mini
jack for battery recharging. Please make sure that it is
the rechargeable batteries inside before plug the recharger
with the mini charge jack.
5
6
3
1
2
5
4
8
6
7
3.3 UL-P/G series, Body Pack Transmitter
Antenna
The antenna is integrated into the transmitter body; to get effective RF transmission,
never cover the antenna with hand, etc.
7
CH/ON Key
Keep pressing this key for a few seconds, the unit will be powered on or off. After it
is switched on, touch this key slightly to select the parameter which you want to edit,
such as the preset channel, PL(RF power level) and Lock/Unlock. In this mode, if
there is no further operation in the next few seconds, it will return to the main menu,
and the LCD displays again the current preset channel, as well as the battery status.
2
1
LCD Display
Generally, the LCD displays the current operation status.
DC 9V
SELECT Key
Use this key to edit the parameters in operation mode. Keep pressing this key for a
few seconds, the unit will enter into the mute mode, repeat for unmute.
4