User's Manual

Menu key
Via this key, you can choose the right function you want.
4 4
UP/DOWN key
In the menu mode, you can choose the right value via these two keys.
Display
The LCD shows RF/AF signal, remaining battery life of the transmitter, group
value, channel value and the selected frequency.
2 2
3 3
It is equipped with two functions, memo function, and auto scan function.
MEM key
5 5
THE REAR PANEL
Antenna Input Socket
Allow you to connect plug-in antennas, remote antennas, or even a complex
antenna network.
XLR Audio Output
This is a professional balanced XLR output connector.
Audio Output Jack
This is a professional unbalanced output jack.
It is used to connect an attached adapter.
1 1
2 2
3 3
DC Input
4 4
3.2 UP-H series , Handheld Transmitter
6
3 3
7 7
6 6
1 1
2 2
4 4
5 5
Fig 12
4.2.3 Battery Replacing And Charging
Please be advised to use only UM3 size AA 1.5V, one pair batteries for power supply.
If the rechargeable batteries are used,
- Please keep the batteries inside, and use the charger (optional accessory, provided
by the manufacturer) to recover the batteries.
- During the charging process, the "Remaining battery life display" flashes.
- Normally, the battery should be recharged within 6-hour.
Note: when the transmitter is muted, the microphone couldn't send out any AF signal, that
means, no sound has been sent out from the microphone.
Remaining battery life display
Fig 13
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
13
2 2
3 3
4 4 1 1
Fig 10: LOCK
Fig 11: UNLOCK
4.2.2 Mute Mode Operation
Keep pressing the SELECT key for a few seconds, the unit will enter into the mute
mode(see the fig 12), repeat to disable mute.