User's Manual Part 1

Use this key to edit the parameters in operation mode. Keep pressing this key for a
few seconds, the unit will enter into the mute mode, repeat for unmute.
SELECT Key
4
4
such as the preset channel, preset group, PL (RF power level), and Lock/unlock; In
this mode, if there is no further operation in the next few seconds, it will return to the
main menu, and the LCD displays again the current preset frequency in MHz, as well
as the battery status.
The unit may be powered from a dry or rechargeable battery.
Please make sure that it is the rechargeable batteries inside before plug the
recharger with the mini charge jack.
Connect the optional recharger(see fig) with this mini jack for battery recharging.
The antenna is integrated into the transmitter body; to get effective RF transmission,
never cover the antenna with hand, etc.
Battery Compartment
5 5
Charge Jack
6
6
Antenna
7 7
3 3
1 1
2 2
5 5
4 4
8 8
6 6
7 7
3.3 UP-8P series, Body Pack Transmitter
7
Extremely rugged spring steel mesh grill to protect the capsule underneath in tough
stage or live performance.
Massive Front Grill
1
1
Generally, the LCD displays the current operation status.
Keep pressing this key for a few seconds, the unit will be powered on or off. After it
is switched on, touch this key slightly to select the parameter which you want to edit,
LCD Display
2
2
CH/ON Key
3
3
Please follow the below procedure to select the proper RF output power,
- Touch the CH/ON key slightly to select the edited parameter of PL (refer to Fig 9),
then use the SELECT key to specify the proper RF output Power version;
- Several seconds later after that, the system stores the settings automatically, and
LCD display comes back to the main menu which shows the current operation status.
- RF Output Power Select
Three different RF output power versions are available of UP-8H,
- PL 0, the output power is 5dBm;
- PL 1, the output power is 10dBm;
- PL 2, the output power is 15dBm;
But, It's a different from UP-8P,
- PL 0, the output power is 3dBm;
- PL 1, the output power is 5dBm;
- PL 2, the output power is 12dBm;
Fig 9
Since the CH/ON and SELECT keys may be easily activated by simple touch, to avoid any
mis-action during the live application, the Lock/Unlock is provided by this system for touch-proof
under the Locked situation.
In case the system is locked, you can still use the CH/ON key to select the edited parameters,
but, except for the Lock/Unlock, others can't be edited.
- LOCK Function
To enter into the Lock mode, please follow the below procedure,
- Touch the CH/ON key slightly to select the edited parameter of Lock/Unlock (refer to Fig 10
& 11), then use the SELECT key to specify Lock or Unlock;
- Several seconds later after that, the system stores the settings automatically, and LCD
display comes back to the main menu which shows the current operation status.
Fig 10: LOCK
Fig 11: UNLOCK
4.2.2 Mute Mode Operation
Keep pressing the SELECT key for a few seconds, the unit will enter into the mute mode
(see the fig 12), repeat for unmute.
12