User's Manual

5
CONTROL ELEMENTS
Receiver screen
Receiver power on
11
11
22
33
44
Mic power display, power
flashing the power Failure
55
66
Frequency display
RFpower indication
AFpower indication
Mic Mute indication
22
33
4455
66
Frequency code
10
OPERATING INSTRUCTION
With the transmitter powered off, install two fresh AA batteries into the MIC .
Leave the battery compartment open.
Turn on the power to the transmitter by pressing and holding Power swith; the indicator LED will
light green.
Press the UP/DOWN button on the front of the receiver to choose an available
channel.
The channel number will increase by two digit,from 00-99.Once the last channel has been
reached, the count will cycle back to 00.
Press and hold the UP/DOWN button for 2 seconds to send the channel information to the
transmitter via infrared transmission.
Press and hold the UP button the display channel will be fast forward.
UP
DOWN / PAIR
IR
CH A CH B
PLL UHF DUAL RECEIVER
UP
DOWN / PAIR
ANT.A
VOLUME.A VOLUME.B POWER
ANT.B
Press and hold the DOWN button the display channel will be fast backward.
77
77
Button lock indication
11
33
44
Press the receiver power button continually.Receiver power on, after 2 secondsdisplay frequency
and r eady.
Receiver p ower o n,press a nd r elease t he p ower b utton t o l ock/unlock t he U P/DOWN b utton.
Press the receiver power button again continually,after 2 seconds have no frequency code display,
then loosen your hand,receiver power off.
If long time does not use the receiver,pls pull out the power adapter from the power jack.
22