User's Manual

Power/Mute Switch
33
BELTPACK MIC
Antenna
11
22
Status Indicator
This permanently attached transmitter antenna should be fully extended during normal
operation.
This LED displays the operation mode:
GREEN
RED
Flashing RED
Normal Operation
Mute
Low Battery
CONTROL ELEMENTS
7
Battery Holder
44
Open the battery holder by pressing the tab and lifting the cover.insert two standard AA(LR6)
batteries here,being sure to observe the plus and minus polarity markings shown.Although
rechargeable Ni-Cad batteries can be used,they do not supply adequate current for more
than four hours.WARNING:Do not insert the batteries backwards;doing so can cause severe
damage to the MIC and will void your warranty.
Input GAIN Control
55
This control adjusts the transmitter input sensitivity.For optimal performance, using the included
screwdriver,
IR Lens
66
This w indow i s u sed t o c apture t he i nfrared s ignal s ent f rom t he d u ring th e IR U P/DOWN
t o c hannelize t he t ransmitter.The b attery c over m ust b e o pen a nd t he I R L ens f acing t owards t he
receiver to load the selected channel.
receiver
Plastic Screwdriver
77
Designed for use in adjusting the MIC input GAIN control(See #5 Input GAIN Control HH).
Set the input GAIN control to where you can see the RF display of receiver
screen become to fulllight, the n turn do wn u ntil the RF displ ay n ot full light (les sth anfive).
Input GAIN Control
This control adjusts the transmitter input sensitivity to work with microphone and instruments
inputs.For optimal performance,using the included screwdriver,
66
Driver
Designed for use in adjusting the MIC input GAIN control.
77
IR Receiving Section
This window is used to capture the infrared signal sent from the receiver during the IR UP/DOWN
to channelize the transmitter.
55
44
MINI 4P CONNECTOR
CONTROL ELEMENTS
8
Pin 1, GND
Pin 4, for Dynamic or condenser microphone
Pin 2, Phantom power supply for Condenser microphone
Pin 3, for Guitar, bass and keyboards
AA
BB
CC
DD
BB
CC
AA
DD
44
11 33 22
77
66
55
11
Set the input GAIN controlt o
where you can see the RF display of U-299R screen become to full light , th en tu rn dow n
until the T he reforedisplay not full light(less than five).
Press and hold to turn the unit on or off. Press and release to mute or unmute the transmitter.
receiver