User's Manual

12
3
12
3
SQUELCH B
MIN MAX
SQUELCH A
MIN MAX
CH B
CH A
S/N
MODEL
11 22 33
6
CONTROL ELEMENTS
66
Power/Mute Switch
55
IR Receiving Section
This window is used to capture the infrared signal
sent from the receiver during the IR UP/DOWN to
channelize the transmitter.
44
Status Indicator
This LED displays the operation mode:
Tail tube
33
PLASTIC HAND MIC
Grille Holder
11
22
Tube
GREEN
RED
Flashing RED
Normal Operation
Mute
Low Battery
55
44
66
METAL HANG MIC
GREEN
RED
Flashing RED
Normal Operation
Mute
Low Battery
Status indicator
11
This LED displays the operation mode:
Power/Mute Switch
22
Battery Cover
33
Unscrew the battery cover and slide down to open
the MIC battery compartment
OPERATING INSTRUCTION
In order for your wireless system to work correctly,both the receiver and transmitter must
be set to the same channel.
With your amplifier or mixer off and volume control all the way down:connect the receiver
output jack to the mic or line level input of a mixer or amplifier using the balanced XLR output or
unbalanced 1/4" line level output.Turn the Level knob on the receiver completely counterclockwise,
then turn its power on.
Follow the basic procedure for setting up and using your receiver wrieless system:
Physically place the receiver where it will be used,and extend the antennas vertically. With
the Power switch on and receiver power off,connect the included power adapter.Turn the receiver
on momentarily to confirm that the unit is receiving power. You will see the LCD display light up.
Then turn receiver power off.
9
UP
DOWN / PAIR
IR
CH A CH B
PLL UHF DUAL RECEIVER
UP
DOWN / PAIR
U-299R
ANT.A
VOLUME.A VOLUME.B POWER
ANT.B
Press and hold to turn the unit on or off. Press and
release to mute or unmute the transmitter.
Press and hold to turn the unit on or off. Press and
release to mute or unmute the transmitter.