SEIKAKU TECHNICAL GROUP LIMITED NF04117 -RS U-299/899 _V1.1 U-299R / U-899H / U-899P/299H 0.06KG/1 A4 5 A3 NH00149(1:1) A4 A5 : 5 PCS 03.23.2014 9 :QHFBE004-20140600016 NO: 1 1.
WIRELESS MICROPHONE SYSTEM User's Manual NF04117-1.
WIRELESS MIC SYSTEM Channel Plans CHB:470-566 MHz CHANNEL TABLE(USA) INDEX Table of Contents 01 SAFETY RELATED SYMBOLS 1 02 WARNING 1 03 IMPORTANT SAFETY INSTRUCTIONS 2 04 INTRODUCTION 3 05 CONTROL ELEMENTS 06 OPERATING INSTRUCTION 07 TECHNICAL SPECIFICATIONS 15 4~8 9~12 12~15
SAFETY RELATED SYMBOLS Unplug this apparatus during lightning storms or when unused for long periods of time. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN External Connection The symbol is used to indicate that some hazardous live terminals are involved within this apparatus, even under the normal operating conditions. The external wiring connected to the output hazardous live terminals requires installation by an instructed person, or the use of readymade leads or cords.
TRANSMITTER Specification MODEL Metal/Plastic hand mic Beltpack mic UHF Oscillation mode PLL UHF SYNTHESIZED FM(F3E) 0.005% PLL UHF SYNTHESIZED FM(F3E) 0.005% RF Radiation Fcc RF Radiation CE 10mW 10mW No naked flame sources, such as lighted candles, should be placed on the apparatus. Spurious Emission 50dBm 50dBm IMPORTANT SAFETY INSTRUCTIONS Frequency stability T.H.D 1.
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna.
OPERATING INSTRUCTION CONTROL ELEMENTS Position the transmitter about 15~30cm from the front of the receiver with the transmitter, s IR window facing the IR transmitter on the front panel of the receiver. Press and hold the receiver UP/DOWN button to set the transmitter to the same channel as the receiver via in frared transmission. When the transmission is complete, the receiver will receive RF signal and tone key from the transmitter.
CONTROL ELEMENTS OPERATING INSTRUCTION Receiver screen With the transmitter powered off, install two fresh AA batteries into the MIC . Leave the battery compartment open. Turn on the power to the transmitter by pressing and holding Power swith; the indicator LED will light green.
OPERATING INSTRUCTION CONTROL ELEMENTS In order for your wireless system to work correctly,both the receiver and transmitter must be set to the same channel. Follow the basic procedure for setting up and using your receiver wrieless system: Physically place the receiver where it will be used,and extend the antennas vertically. With the Power switch on and receiver power off,connect the included power adapter.Turn the receiver on momentarily to confirm that the unit is receiving power.
CONTROL ELEMENTS 4 Battery Holder Open the battery holder by pressing the tab and lifting the cover.insert two standard AA(LR6) batteries here,being sure to observe the plus and minus polarity markings shown.Although rechargeable Ni-Cad batteries can be used,they do not supply adequate current for more than four hours.WARNING:Do not insert the batteries backwards;doing so can cause severe damage to the MIC and will void your warranty.
