User manual

Further configuration options
20 Manual Connection Service.fm
© ThinPrint GmbH 2015
Illus. 19
Illus. 19 Configuring IP addresses and TCP ports
– Close the configuration program by clicking OK.
– Lastly, restart the TP C
ONNECTION SERVICE in the Windows Services folder.
Client IDs
A client ID including authentication key must be stored in the Connection Service
access database for every end device that is allowed to use the ThinPrint Connection
Service (see below). These two values must also be set up in each ThinPrint Client
(Illus. 7). Note also that a ThinPrint license is required for each client ID
7
.
Database
Set up client IDs as follows:
– Open the command prompt and change to the Connection Service installation
directory (Page 14).
– Set up the client ID that you previously set up in ThinPrint Client Manager.
For the example in Illus. 7, enter the following command line:
TPConnect -add 99:111
To get an overview of used licenses and to delete entries from the database, proceed
as follows:
– Pause the Windows TP C
ONNECTION SERVICE service.
– In the Connection Service installation directory, open TPConnect.mdb with
Microsoft Access.
– Then click on A
CTIVESESSIONS (Illus. 20, arrow).
– Here, you could delete a line, if necessary.
7 ThinPrint License Manager can be started from the command prompt with Licman.exe.