User manual

Further configuration options
18 Manual Connection Service.fm
© ThinPrint GmbH 2015
Illus. 17
Illus. 17 Printers created on a Windows terminal server by AutoConnect - printing to
Windows workstation (TP Output Gateway)
The two printers in Illus. 17 can now be used for the duration of a terminal server
session.
Print test
Now test the Connection Service installation. Print using the newly created printers
(Illus. 17) on both network printers. The user who is printing must be enabled for
ThinPrint on the license server (Page 24
).
Further configuration options
In addition to the configuration of the Connection Service on Page 14, the Connection
Service functions are described in more detail below.
Configuration of the Connection Service
Start the configuration program of Connection Service in the command prompt
(from its installation directory) with:
TPConnect -setup
This opens the window shown in Illus. 18.
Session manager
There is only one value
6
that can be configured on the SESSION MANAGER tab:
M
AX. CLIENT RECONNECT TIME
This value specifies the timeout for printing in case the Connection Service receives
a print job but the ThinPrint Client for which the print job is intended is no longer
connected with the Connection Service. If ThinPrint Client returns within the given
time, the print job will be sent to it; otherwise, the print job will be deleted.
The value is set in seconds (default: 80 s). See also “ReconnectTO”, Page 23
.
6 The other two values are used for configuring dynamic mode, which is not used here.