User manual

Maintenance
TPG User Manual 76
The phases are described in the following:
[Phase 1] Reset [Phase 2] Restart of the device
Turn off the TPG
(interrupt the power supply).
Turn off the TPG
(interrupt the power supply).
Remove the network cable
(RJ-45) from the TPG.
Connect the network cable
(RJ-45) to the TPG.
Press and hold the status/reset
button.
Turn on the TPG
(establish the power supply).
Turn on the TPG
(establish the power supply).
The activity LED will then be
permanently lit in orange.
After a few seconds, the activity
LED will alternatingly blink
green and red.
Press and hold the status/reset
button for a short time.
The status page is printed.
Wait until the activity LED will
blink orange.
Release the status/reset button
for about 1 second.
The activity LED alternatingly
blinks green and red.
Press and hold the status/reset
button again.
The activity LED blinks orange
twice.
Release the status/reset button.
The activity LED blinks green.
[Phase 3] Status check