User manual

Maintenance
TPG User Manual 75
3. Click Default settings.
ª The parameters are reset.
Resetting Parameters via the InterCon-NetTool
Proceed as follows:
1. Start the InterCon-NetTool.
2. Highlight the TPG in the device list.
3. Select Actions – Default Settings from the menu bar.
4. Click Finish.
ª The parameters are reset.
Resetting the parameters via the status/reset button
LEDs, various ports and the status/reset button can be found on the
TPG. These components are described in the 'Quick Installation
Guide'.
Using the status/reset button you can reset the parameter values of
the TPG to their default settings. The reset process can be divided
into three phases.
• During phase one, the TPG is forced into the reset mode. During
the reset mode, the parameters are reset.
• The second phase describes the restart of the device.
• The third phase describes the printing of a status page. The reset
process can be checked by means of the status page.
IMPORTANT: The reset mode is indicated if the activity LED is
alternatingly blinking green and red. The activity LED will then
blink orange.
You must release the status/reset button at this moment,
otherwise the TPG switches to the BIOS mode. If this happens, try
the reset again.