User manual
Maintenance
TPG User Manual 73
Automatic print job buffering
Requirements
; A USB flash drive has been connected to the TPG.
; The USB flash drive has been formatted correctly; see: Ö72.
Proceed as follows:
1. Start the TPG Control Center.
2. Select MAINTENANCE – USB device.
3. Tick Print job buffering.
4. Click Save & Restart.
ª The settings are saved.
Saving the Parameter Values Automatically
Requirements
; A USB flash drive has been connected to the TPG.
; The USB flash drive has been formatted correctly; see: Ö72.
Proceed as follows:
1. Start the TPG Control Center.
2. Select MAINTENANCE – USB device.
3. Tick Parameter backup.
4. Click Save & Restart.
ª The settings are saved.
Loading the Parameter Values Automatically to a TPG
Requirements
; The USB flash drive has been formatted correctly; see: Ö72.
;
A parameter file exists on the USB flash drive; see:
Ö
71.
Proceed as follows:
1. Connect a USB flash drive to the USB port of the TPG.
ª The parameter values in the file are automatically applied to the
TPG.