User manual

ThinPrint Settings
TPG User Manual 43
The support of the transfer methods depends on the printer. Consult
your printer manual for more information.
Proceed as follows:
1. Start the TPG Control Center.
2. Select DEVICE – ThinPrint®.
3. Enter the printer parameters into the boxes; see: Table 9
Ö43.
4. Select a transfer method for every printer.
5. Click Save & Restart to confirm.
ª The settings are saved.
Table 9: Printer Parameters
Parameters Description
ID The ID clearly identifies the printers for the ThinPrint
server.
Printer Defines the printer name. The printer name is purely a
description and is used to distinguish the printers.
The printer can only use the ThinPrint AutoConnect
feature if a printer name was defined. If the printer
supports SNMP, the printer class is derived automatically
via SNMP. A freely definable description can be entered
at any time and will override any automatically derived
printer name.
Class Printers with compatible drivers can be arranged in one
class.
In addition to the defining of the printer name, you can
also define a printer class if you want to use the ThinPrint
AutoConnect feature. If the printer supports SNMP, the
class name is obtained automatically via SNMP. A freely
definable description can be entered at any time and will
override any automatically derived class name.
Driver Defines the printer driver for the ThinPrint® AutoConnect
feature.
Printer address Defines the IP address or host name of the printer.
The host name can only be used if a DNS server was
configured beforehand.