User manual

Network and Device Settings
TPG User Manual 26
3.1 How to Configure IPv4 Parameters
TCP/IP (Transmission Control Protocol over Internet Protocol)
forwards data packets across several connections and establishes a
connection between the network participants.
The boot protocols DHCP and BOOTP belong to the TCP/IP protocol
family. You can define various IPv4 parameters for an ideal
integration of your TPG into a TCP/IP network. For further
information about the assignment of IP addresses, see:
Ö13.
What do you want
to do?
 ’Configuring IPv4 Parameters via the TPG Control Center’ Ö26
 ’Configuring IPv4 Parameters via the InterCon-NetTool’ Ö27
Configuring IPv4 Parameters via the TPG Control Center
Proceed as follows:
1. Start the TPG Control Center.
2. Select NETWORK - IPv4.
3. Configure the IPv4 parameters; see: Table 2 Ö26.
4. Click Save & Restart to confirm.
ª The settings are saved.
Table 2: IPv4Parameters
Parameters Description
DHCP
BOOTP
ARP/PING
Enables or disables the protocols DHCP, BOOTP, and
ARP/PING.
Protocols offer various possibilities to save the IP address
in the TPG.
(See ’Saving the IP Address in the TPG’
Ö 13.)
We recommend disabling these options once an IP
address has been assigned to the TPG.
IP address IP address of the TPG
Subnet mask Subnet mask of the TPG
Gateway Gateway address of the TPG