Installation guide

12 [en] Quick Installation Guide
Assigning an IP Address to the TPG-25
Once the TPG-25 is connected to the network, it checks whether an IP address
can be obtained via the boot protocols BOOTP or DHCP. If this is not the case, the
TPG-25 assigns itself an IP address via ZeroConf from the address range
(169.254.0.0/16) which is reserved for ZeroConf.
Once the TPG-25 has automatically received an IP address via a boot protocol,
you can save a freely definable IP address in the TPG-25.
Wizards facilitate the installation and configuration of network devices via the
InterCon-NetTool. Wizards are subprograms aimed at querying required
parameter values.
The 'IP Wizard' is available for the TPG-25. You can easily enter the desired IP
address and save it in the TPG-25 using the IP Wizard.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Mark the TPG-25 in the device list.
The TPG-25 is displayed in the device list under IP- 'ZeroConf' with an IP address from
the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the IP Wizard.
 The settings are saved.