User manual

Maintenance
mySND User Manual 95
The phases are described in the following:
[Phase 1] Reset [Phase 2] Restart
Switching off the SND Server
(interrupt the power supply).
Switching off the SND Server
(interrupt the power supply).
Press and hold the reset
button.
Switching on the SND Server
(establish the power supply).
Switching on the SND Server
(establish the power supply).
Wait until the activity LED and
status LED blink
synchronously.
The reset mode has been
activated.
Release the reset button for
about 2 seconds.
The LEDs blink alternatingly.
Press and hold the reset button
again.
The LEDs blink synchronously.
After a few seconds, only the
activity LED will blink.
Release the reset button.