User manual

Maintenance
mySND User Manual 94
Resetting Parameters via the InterCon-NetTool
Proceed as follows:
1. Start the InterCon-NetTool.
2. Highlight the SND Server in the device list.
3. Select Actions – Default Settings from the menu bar.
4. Click Finish.
ª The parameters are reset.
Resetting the Parameters via the Reset Button
LEDs, the reset button and various ports can be found on the SND
Server. These components are described in the 'Quick Installation
Guide'.
Using the reset button you can reset the SND Server’s parameter
values to their default setting. The reset process can be divided into
two phases:
• During phase 1, the device is forced into the reset mode. During
the reset mode, the parameters are reset.
• The second phase describes the restart of the device.
IMPORTANT: The reset mode is indicated by the synchronous
blinking of the activity LED (yellow) and the status LED (green)
and last for about five intervals.
You must release the reset button within this time frame,
otherwise the device switches to the BIOS mode. If this happens,
try the reset again.