User manual
Network Settings
mySND User Manual 34
Table 6: POP3 Parameters
Configuring SMTP
Requirements
; The SND Server is set up as user with its own email address on an
SMTP server.
Proceed as follows:
1. Start the mySND Control Center.
2. Select NETWORK - Email.
3. Configure the SMTP parameters; see: Table 7 Ö35.
4. Click Save & Restart to confirm.
ª The settings will be saved.
Parameters Description
POP3 Enables/disables the POP3 functionality.
POP3 - Server name Defines the POP3 server via the IP address or the host
name.
The host name can only be used if a DNS server was
configured beforehand.
POP3 - Server port Defines the port used by the SND Server for receiving
emails. The port number 110 is preset. When using
SSL/TLS, enter 995 as port number.
POP3 - Security Defines the authentication method to be used
(APOP/SSL/TLS). When using SSL/TLS, the cipher
strength is defined via the encryption level
Ö69.
POP3 - Check mail every Defines the time interval (in minutes) for retrieving emails
from the POP3 server.
POP3 - Ignore mail
exceeding
Defines the maximum email size (in Kbyte) to be
accepted by the SND Server.
(0 = unlimited)
POP3 - User name Defines the user name used by the SND Server to log on
to the POP3 server.
POP3 - Password Defines the password used by the SND Server to log on
to the POP3 server.