User manual

Network Settings
mySND User Manual 26
2. Select NETWORK - IPv4.
3. Configure the IPv4 parameters; see: Table 2 Ö26.
4. Click Save & Restart to confirm.
ª The settings will be saved.
Table 2: IPv4 Parameters
Configuring IPv4 Parameters via the InterCon-NetTool
Requirements
; The InterCon-NetTool is installed on the client, see: Ö20.
; The network scan via Multicast has been enabled in the
InterCon-NetTool.
; The router in the network forwards multicast requests.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Highlight the SND Server in the device list.
The SND Server is displayed in the device list under 'ZeroConf' with an IP
address from the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the Wizard.
ª The settings will be saved.
Parameters Description
DHCP
BOOTP
ARP/PING
Enables or disables the protocols DHCP, BOOTP, and
ARP/PING.
Protocols offer various possibilities to save the IP
address in the SND Server.
(See ’Saving the IP Address in the SND Server’
Ö12.)
We recommend disabling these options once an IP
address has been assigned to the SND Server.
IP address IP address of the SND Server
Subnet mask Subnet mask of the SND Server
Gateway Gateway address of the SND Server