Installation guide

12 [en] Quick Installation Guide
Assigning an IP Address to the mySND-120
Once the mySND-120 is connected to the network, it checks whether an IP
address can be obtained via the boot protocols BOOTP or DHCP. If this is not the
case, the mySND-120 assigns itself an IP address via ZeroConf from the address
range (169.254.0.0/16) which is reserved for ZeroConf.
Once the mySND-120 has automatically received an IP address via a boot
protocol, you can save a freely definable IP address in the mySND-120.
Wizards facilitate the installation and configuration of network devices via the
InterCon-NetTool. Wizards are subprograms aimed at querying required
parameter values.
The 'IP Wizard' is available for the mySND-120. You can easily enter the desired IP
address and save it in the mySND-120 using the IP Wizard.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Highlight the mySND-120 in the device list.
The mySND-120 is displayed in the device list under IP - 'ZeroConf' with an IP address
from the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the IP Wizard.
 The settings will be saved.