User manual

User’s Manual InterCon-PrintServer

9 BS2000 (TCP/IP) Installation

RS0 Spooler Version 2.3A and Version 3.0A:

The print server supports the TCP/IP protocol for BS2000. A valid IP address must have been saved

on the print server.

To enter an IP address on the print server please use the Windows Administrations Tool (IPX

protocol) or the

arp

and

ping

programs (TCP/IP).

Edit the ARP table

arp -s <Internet address> <Hardware address>

Example:

arp -s 192.0.0.123 00:c0:eb:00:01:ff

✘✘

Within some operating systems, for example all Microsoft Windows systems (except Windows

NT 4.0), you must contact a workstation in the network via the

ping

command before using

the

arp

command for the first time. If this is not possible in your network you have to use the

Administration Tool (IPX protocol) for configuration.

Assign a new IP address to the print server.

ping <Internet address>

Example:

ping 192.0.0.123

Install the InterCon-PrintServer with its IP address in the RS0 spooler. Use the TCP-Port address

2900 (logical printer No. 8) for this.

Default Values for logical printer No. 8:

lp8_tcp_port = 2900

lp8_job_start =

lp8_job_end =

lp8_crlf = off

lp8_banner = off

lp8_ascii_ps = off

lp8_hexdump = off

lp8_rso_spool = on