User manual

User’s Manual InterCon-PrintServer
48
6.1 Windows95 (SEH Print Monitor)
This chapter describes the installation of a print server under Microsoft Windows 95. Use the SEH
PrintMonitor to install the print server to Windows95 peer to peer networks. All print jobs will be
sent via TCP/IP protocol to the print server.
•
install the TCP/IP protocol on your Windows95 PC
•
assign an IP address to the print server
•
open a „MS-DOS“ window
•
change the ARP table
arp -s <Internet Address> <Hardware Address>
Example:
arp -s 192.0.0.123 00-c0-eb-00-01-ff
✘ ✘
Within some operating systems, for example all Microsoft Windows systems (except Windows
NT 4.0), you must contact a workstation in the network via the
ping
command before using
the
arp
command for the first time. If this is not possible in your network you have to use the
Administration Tool (IPX protocol) for configuration.
•
assign a new IP address to the print server
ping <Internet address>
Example:
ping 192.0.0.123
•
install a new printer as local printer. Use LPT1: printer as the assigned printer port
•
start the
PRINTMON.EXE
installation program. Follow all prompts.