User manual

User’s Manual InterCon-PrintServer
105
10.2 Status Button
You can print a the print server status page and a list of all print server parameters by pressing the
status button. This button can also be used to reset the print server back to its default settings.
10.2.1 Default Setting / Download Mode
In order to set all parameters back to their default values, switch the print server on and press the
status button simultaneously (both LEDs flash fast). Release the button (both LEDs flash
alternately). If you press the status button again within 5 seconds, the print server will reset to its
default values (both LEDs flash 3 times to indicate this). Now the print server stays in download
mode (indicated by the flashing red LED). If you should miss the 5 sec time limit for pressing the
status button the print server ends up in this mode. After being switched off and on all parameters of
the print server remain unchanged.
Sw itch on the printer
with pressed status button
(LED 's are flashing fast)
No max. 5 sec
max. 5 sec
No
Release status button
(LED's are blinking alternately)
Press status button again
(LED's are blinking three times)
Default Setting
Download Mode
(Red LED is flashing fast)
Action Reaction of LED's