User Manual

1211
Install Headlight (for X260 only)
1. Affix the headlight to the installation plate on the
front fork.
2. Install the headlight, adjust to the right angle and
tighten the lock bolts on both sides.
Install Front Wheel
1. Use a 4 mm Allen wrench to loosen
the 4 bolts on the front fork.
2. Use an 8 mm Allen wrench to take
off the 2 nuts on the front wheel
axle, then knock gently to take out
the front wheel axle.
3. Put the axle plug on both sides of
the front wheel. Be careful not to
damage the sealing ring.
1. Adjust the front brake lever and the
accelerator to the correct angle.
2. Use 4 mm / 5 mm Allen wrench to
tighten the accelerator and front
brake respectively.
3. Check to make sure the accelerator
works smoothly.
* If there's jamming, adjust the angle
and check if the cables are stuck.
Ax Front Brake Lever and Accelerator
4. Take off the clamp from the disc brake clipper. Install the front wheel in the front fork (make sure it's well matched with
the disc brake’s clipper).