User Manual

1009
User Manual
User Manual
Charger
X260
X160
Right Foot Peg
Quick-start Guide
Quick-start Guide
Limited Warranty and
Dispute Resolution
Limited Warranty and
Dispute Resolution
Keys x 2
Nylon Strip (7.9 inch /
200 mm) x 4
(For X260 only)
To o l K i t
(4 / 5 / 8 mm Allen wrench;
14 mm open-end wrench)
Front Number Plate
(For X260 only)
Battery
Torque Index Card
To r q u e I n d e x C a r d
(Torque values for
tightening screws,
nuts and bolts)
Cushioning Foam
4 Assembly
Install Handlebar
1. Use a 4 mm Allen wrench to loosen the 4 lock screws
(with washers) and take off the handlebar stem cap.
2. Install the front brake lever, then the accelerator on
the handlebar.
* Do not tighten the nuts.
3. Insert the handlebar and affix the handlebar stem cap.
Align with the marking and fit the handlebar to the
right direction and angle.
4. Tighten the 4 lock screws. Refer to Torque Index Card
for torque specs.
Please follow the instructions to assemble the vehicle. Improper assembly can lead to rider injury or
vehicle damage.