User Manual

2827
2. Disconnect the communication plug and discharge plug. 3. Pull out the battery and close the battery compart-
ment cover.
Precautions:
● While charging, place in a safe place inaccessible to children.
● When charging, do not cover the charger. Use and store in a dry and well-ventilated place.
● If the charger emits an odor or becomes very hot, or the battery cannot be fully charged, please contact after-sales service.
* When charging, the charger indicator flashes red.
When the battery is full, the indicator turns green.
Please disconnect the charger from the power socket
when fully charged, and turn the main switch on after
you reinserted the battery into the Segway Dirt eBike.
4. Connect the charger output to the battery charging
port and then plug the charger into a power socket.
WARNING
● Battery pack must match with charger. Please use the original battery that comes with the package. Damage or
malfunction caused by the installation or use of any other charger not approved by Segway will void the warranty of
your Segway Dirt eBike.
● The main switch must be turned off before installing or removing the battery, otherwise the life of the battery
discharge plug will be reduced. If the main switch is on, there may be sparks when you connect the battery plugs,
which may cause damage to the plugs or battery.
Charge the Battery
1. Make sure the electric lock is turned off. Open the battery compartment and turn off the main switch.