Specifications

September 2011 22743-00001 ab

4. Check that the mats are intact, secured, and free of debris. It is appropriate to replace a mat if

any worn edges or tears are observed. For replacement instructions, see the Segway PT

Reference Manual.

5. Check tires and wheels for wear, tightness, and tire pressure. i2 tires should be inflated to 15 psi,

x2 and x2 Turf tires to 4 psi. Wheel nuts should be torque to 30 N-m.

Excessive tire wear is determined as follows:

• Model i2 – Center rib is worn flush with tire surface

• Model x2 – Diamond pattern on center rib is no longer visible

• Model x2 Turf – Tire tread depth is less than 3/32” (2.38 mm)

See page 10 of this document for visual examples.

6. Power the Segway PT on and off twice to

ensure it is able to power on and off reliably.

Confirm that the Wireless InfoKey controller is

displaying a “happy face” icon as seen in the

image to the right.

7. Check that the fenders are intact, secured, and free of debris. The fenders on the Segway PT are

designed to protect the rider from debris. The fender will also shield the rider from having the tire

rub against their leg while leaning in turns. Cracked or otherwise broken fenders should be

replaced. For replacement instructions see the Segway PT Reference Manual.

8. Turn on the Segway PT and test the rider detect sensors. When your feet are properly positioned

on the rider mats, all four rider detect sensors depress, allowing the Segway PT to operate

normally in Balance Mode. See the Segway PT Reference Manual for more details.