User manual

Recalibrating the Battery Charge Level Display

WARNING

Do not ride your Segway PT to full Battery depletion. To safely discharge

Batteries below the bottom bar, you should leave your PT powered on in

Balance Mode leaning against a wall in a secure location.

CAUTION

To avoid injury, damage, and to deter theft, be sure your Segway PT

discharges in a safe, secure location, powered on in Riderless Balance Mode.

The PT shows the Battery charge level in the InfoKey Controller, as described

in "Reading the Battery Charge Level Display" (p. 90). The display may be

inaccurate after long periods of storage, or during initial use.

To recalibrate the display:

1. Fully charge the Batteries for 12 hours.

2. Discharge the Batteries (through normal use of the PT) until the

bottom bar in the Display is blinking, representing approximately 10

percent Battery charge remaining (see Figure60).

3. Leave your PT in a safe, secure location, powered on, until the Bat-

tery charge is fully depleted, and your PT powers down.

NOTE:

Depleting your PT Batteries from the bottom bar to empty could

take several hours.

4. Fully recharge the Batteries for a minimum of 12 hours, after which

the Battery Charge Level Display will be recalibrated.

Figure 60: InfoKey Showing Approximately 10% PT Charge Left