User manual

53
NOTE:
Conditions that may cause the Speed Limiter to activate when you are travel-
ing at less than the maximum speed allowed for your operating mode include:
• Riding up or down a steep hill
• Riding on bumpy terrain
• Riding with fewer than three Rider Detect Sensors depressed
• The first few seconds after you power on and step on the Powerbase
• Low Battery charge
• Batteries that are too hot or too cold
• Riding down a hill with fully charged Batteries
Because of regenerative charging, if the Batteries are fully charged, the PT will
activate the Speed Limiter to avoid overcharging.
Table 6 shows the icons that display on the InfoKey Controller when the
Speed Limiter is engaged at a speed lower than the top speed set by the In-
foKey Controller. This table also describes the error that has occurred and the
recommended action you should take.
Table 6: Speed Limiter
Display Icon Description Recommended
Action
The PT is
operating
at reduced
performance
levels due to
a temporary
condition.
The speed
limit has been
lowered until
the condition
clears.
When the Speed
Limiter pushes
the Handlebar
back, stop
leaning forward
and slow down.
Always leave a
gap between
yourself and the
Handlebar.