User manual

49
Activating the Training Safety Shutdown
WARNING
Before you demonstrate a Safety Shutdown for training purposes, you must
read "Safety Shutdown" (p. 57) and watch the Safety Video.
The purpose of demonstrating a Safety Shutdown is to introduce the rider to
the experience while in a predictable, controlled environment with a spotter.
1. Make sure the PT is in Balance Mode.
2. The rider should stand on the Mats with the PT remaining stationary.
3. The spotter should firmly hold the PT, ready to keep it steady and
stationary when the Safety Shutdown begins.
4. A third person should hold the InfoKey Controller, and confirm that
both the rider and the spotter are ready.
5. The third person may then press and hold both the Information Dis-
play button and the Power/Standby button simultaneously until the
Safety Shutdown initiates. Figure 26 shows the InfoKey Controller
display during a training Safety Shutdown.
6. The spotter must continue holding the PT so it does not move.
7. The rider must step off the PT before 10 seconds elapse.
In a non-training Safety Shutdown, the rider has approximately 10 seconds
from the start of the Safety Shutdown to come to a controlled stop and step
off. After 10 seconds, the PT will immediately shut down when the Wheels
reach zero speed.
Figure 26: InfoKey Controller Display During Training Safety Shutdown
Information Display button
Power/Standby button