User manual

42
InfoKey Controller (cont.)
Power/Standby Button Functions
The following functions can be performed using the Power/Standby button.
Powering On and Off
To power on the PT:
1. Stand no more than 15 ft. (5 m) from your PT.
2. To power on, tap the Power/Standby button.
3. To power off, press the Power/Standby button for 2 seconds.
The PT will only power off when no Rider Detect Sensors are depressed (when there is no weight on the Mats).
Switching to Standby Mode from Balance Mode
1. Ensure the PT is powered on and in Balance Mode.
2. To switch to Standby Mode, tap the Power/Standby button.
3. Confirm that there is no face in the Display and that no Balance Indicator Lights are flashing.
If all four Balance Indicator lights are green and flashing, the PT is still in Balance Mode. The PT will only switch to Standby mode when no Rider
Detect Sensors are depressed (when there is no weight on the Mats).
See "Balance Mode/Riderless Balance Mode" for more information (p. 31).
NOTE: If the InfoKey Controller display becomes blank while the PT is being ridden, simply tap the Power/Standby button to refresh the
display. The PT will stay in Balance Mode, allowing full and proper operation.