User manual
19
3. Position the Handlebar Clamp against the Handlebar.
4. Insert the 3 fasteners through the Handlebar Clamp into the
LeanSteer Frame.
5. Using the 3 mm hex wrench, alternate between the 3 fasteners,
evenly tightening in small increments.
6. Check to ensure that the gap between the Handlebar Clamp and
the LeanSteer Frame is even, and the same between the top and
bottom. Tighten to 2.0N-m(18in-lbf).
Attach the LeanSteer Frame
Tool Required: Torque wrench with 5 mm bit
WARNING
The LeanSteer Frame must be properly attached and secured. Failure to
properly assemble the LeanSteer Frame and/or maintain torque on the
fasteners could lead to an unexpected change in steering and result in
serious injury and/or damage to your Segway PT from loss of control,
collisions, and falls.
To attach the LeanSteer Frame to the Powerbase:
1. Make sure the PT is unplugged and powered off.
2. Place the LeanSteer Frame onto the stem.
3. Install the two fasteners; do not tighten.
4. Make sure the LeanSteer Frame is standing straight vertically, then
torque the fasteners to 11.0N-m(8.1ft-lbf).
Figure 5: Attach LeanSteer Frame to Stem