User manual

18
Assembling Your Segway PT (cont.)
To Set Up your Segway PT, follow the procedures below in the order listed.
For the name and location of specific PT components, see "Segway PT
Components and Subsystems" (p. 27).
Prepare the LeanSteer Frame
Tool Required: None
The LeanSteer Frame is collapsed to its shortest length for shipping.
Assembly is required before adjusting the Handlebar height for the first time.
To extend and assemble the LeanSteer Frame:
1. Remove the Height Adjustment knob (see Figure 9, page 21) by
turning the knob counterclockwise.
2. Extend the upper bar of the LeanSteer Frame by sliding it up from
its storage position until the slot for the Height Adjustment fastener
is visible.
3. Reinstall the Height Adjustment knob by turning and tightening the
knob clockwise.
Attach the Handlebar
Tool Required: Torque wrench with 3 mm bit
To attach the Handlebar to the LeanSteer Frame:
1. Make sure the Segway PT is unplugged and powered off.
2. Align the Handlebar in place against the LeanSteer Frame using the
alignment guides.
Figure 4: Attach the Handlebar
Handlebar
Fasteners
Handlebar clamp
Alignment guide