User manual

127
InfoKey Controller Error Icons
InfoKey Controller icons assist you in diagnosing certain errors. Match the
icon shown in your InfoKey Controller display to those in the tables in this
section to identify and attempt to correct the fault.
WARNING
Do not step onto the Segway PT Mats until you have cleared all error
conditions and have confirmed the PT is in Balance Mode.
Startup Error Conditions
If you attempt to power on the PT and an error condition occurs that prevents
the PT from powering on and entering Standby Mode, the icons shown in
Table14 will appear on the InfoKey Controller.
To clear these conditions, follow the instructions in the Recommended
Action column in Table14.
Table14:IconsforStartupErrors
Display Icon Description Recommended
Action
The Segway
PT is plugged
in.
Unplug the Power
Cord. If the Segway
PT has powered off,
power on again.
The Charge in
the Segway
PT batteries
is too low
to operate
safely.
Charge the
batteries, then
attempt to power
on.
A Rider
Detect
sensor is on
at startup.
Ensure your foot
is not on the Mat
and the Mat is free
of foreign objects
and not sticking
to the Powerbase.
Remove, inspect,
and reinstall the
Mats.