User manual

115
Replacing the InfoKey Controller Battery
Tool Required: Coin or flathead screwdriver
To replace or reseat the InfoKey Controller battery:
1. Make sure the Segway PT is unplugged and powered off.
2. Remove the InfoKey Controller from the Dock and unscrew
the InfoKey Controller Dock Adapter (see "Undock the InfoKey
Controller," p. 117).
3. Using a coin or Flathead screwdriver, unscrew the back cover of the
InfoKey Controller.
4. Remove the InfoKey Controller battery.
5. If you are replacing the battery, verify the new battery is type
CR2430. These batteries are available at electronics stores.
NOTE:
Dispose of used batteries properly in accordance with local
regulations governing disposal of toxic materials.
6. Insert the InfoKey Controller battery with the positive (+) side
facing up.
7. Screw on the InfoKey Controller back cover.
8. Screw on the InfoKey Controller Dock Adapter.
+
Figure 76: Replacing the InfoKey Controller Battery