User manual

114
Service Procedures (cont.)
Remove/Install the Mats
Tools Required: None
To remove a Mat:
1. Make sure the Segway PT is unplugged and powered off.
2. Lift the Mat off the Powerbase.
To install a Mat:
1. Make sure the Segway PT is unplugged and powered off.
2. Verify the top of the Powerbase and bottom of the Mat are clean, dry,
and free of debris.
3. Place a Mat on the Powerbase.
4. Fit the Mat's rubber tabs into the Powerbase grooves.
5. Tuck the tabs in place around the entire perimeter of the Mat,
begining with the side of the Mat nearest the console. Press down
on the Mat while you tuck in the tabs.
6. Visually confirm the Mat is properly aligned and all rubber tabs are
tucked in prior to riding.
Figure 75: Install the Mats