User manual

111

Remove the x2 SE Tire/Wheel Assembly

Tools Required: 13 mm socket wrench

1. Make sure the Segway PT is unplugged and powered off.

2. Tip the PT on its side so the Wheel you want to remove is facing up,

and the bottom wheel rests against a smooth, clean surface.

3. Using a 13 mm socket wrench, remove the three wheel nuts and

discard (see Figure 71).

4. Remove the tire/wheel assembly.

Install the x2 SE Tire/Wheel Assembly

Tools Required: 13 mm socket, torque wrench

1. Make sure the Segway PT is unplugged and powered off.

2. Ensure the PT is on its side, and the gearbox ﬂange is clean and free

of debris.

3. Place the Tire/Wheel assembly onto the gearbox ﬂange (see

Figure 71).

4. Holding the wheel to prevent rotation, use a 13 mm socket wrench

to tighten the three wheel nuts included with the kit and torque to

30N-m(22ft-lbf).

Figure 71: Remove/Install the x2 SE Tire/Wheel Assembly

Wheel Nuts

Tire/Wheel Assembly

Gearbox Flange