User manual

110
Service Procedures (cont.)
Remove/Install the i2 SE Fenders
Tools Required: T20 six-lobe wrench, torque wrench with T20 six-lobe bit
To remove the i2 SE Fenders:
1. Make sure the Segway PT is unplugged and powered off.
2. Remove the Tire/Wheel Assembly (see "Remove the i2 SE Tire/
Wheel Assembly," p. 108).
3. Remove the four fasteners that attach the Fender to the Gearbox.
4. Remove the Fender.
To install the i2 SE Fenders:
1. Position the Fender so it aligns with the four holes in the Gearbox.
2. Thread the four fasteners through the Fender to the Gearbox and
tighten to 1.5N-m(13in-lbs).
3. Install the Tire/Wheel Assembly (see "Install the i2 SE Tire/Wheel
Assembly," p. 109).
Figure 70: Remove/Install the Fenders