User Manual

* NOTE
1. Before removing and installing the battery, turn off the electronic lock and turn off the main switch.
Then, cover the rubber seal cap of the charging port.
2. Do not force the battery into the battery compartment.
Tip: It is recommended to store the battery at an indoor temperature of more than 32 °F (0°C) and
regularly check the battery in winter. Do not store the battery in temperatures above 122 °F (50°) or below
14 °F (-10° F).
Battery charging and charger use
● Use the original charger only. This prevents the battery from damage or other dangers.
● Check whether the input voltage of the charger is consistent with the power socket voltage.
● The charger will be turned off automatically after the battery is fully charged. However,do not charge
the battery or keep the charger connected to a power socket for more than 6 hours.
● Do not dismantle the battery without permission, in order to avoid damage and danger.
● The battery should be reactivated after over-discharge protection. See row 7 of “Troubleshooting” in the
user manual.
Maintenance of motor and controller
● Regularly check that motor screws are not loose.
● Regularly check that the connecting wires of the motor and controller are not loose and are
properly insulated.
● Regularly check that the fuse is not loose.
● Do not ride in deep water to avoid damaging motor operation.
* NOTE
The vehicle will automatically run with low power output in the event of excessively high motor or
controller temperature or low remaining battery. This does not indicate faulty behavior.
Warning
When operating the vehicle in water or mud, the depth must not exceed the center of the wheel. In other
words, no deeper than the height of the axle. Long-time immersion of the motor in water may lead to
motor failure.
3433
Fuse replacement
If the dashboard, horn, and light do not work after the main switch and electric lock are enabled; it
indicates a blown fuse. If this occurs, please replace the fuse.
Specific operations for fuse replacement are as follows:
1. Open the battery compartment cover, pull out the battery, and then open the fuse box in front of the
main switch.
2. Remove the damaged fuse, take out the spare fuse in the battery compartment cover, and then install
the fuse. After you close the fuse box, install the battery, and then close the battery compartment cover.
* NOTE
● Install the fuse securely. Loosening of the plug-in part may lead to fuse heating and other faults
and dangers.
● Replace the fuse with that of the specified model and specification (of equal current and voltage
rating). Otherwise, the fuse may fail in protection.
● If the fuse is blown, a short time after replacement, identify other possible causes in addition to the
fuse itself.
● Protect the fuse from water intrusion or high-pressure water flow.
* NOTE
In case of an accident or breakdown, please contact an authorized repairer if the product is still under
warranty. If not, you can contact any specialized repairer of your choice. You can ask for the list of the
authorized repairers from the customer service available at www.segway.com. Efforts have been made to
simplify wording in the user manual. When an action appears too complicated, you are advised to contact
an authorized or a specialized repairer or customer service.