Test Report

Report Reference No.: 50337286 001
CSA C22.2 No. 107.1
Clause
Requirement – Test
Result – Remark
Verdict
Page 69 of 75
Clauses 4.24.2 to 4.24.11 apply to all types of liquid
preservation systems; Clause 4.24.12 applies to conservator
tank systems; Clause 4.24.13 applies to sealed tank systems;
and Clause 4.24.14 applies to nonsealed tank systems.
N/A
4.24.2
Liquid Level
Not Dielectric-Liquid-Filled
Equipment
N/A
The cold-liquid level at 25°C shall be clearly marked on the
liquid-level gauge of PCE so equipped, and on the inside of the
tank on PCE not so equipped. For PCE with welded covers,
internal markings shall not be required.
N/A
4.24.3
Liquid Drain Valve
Not Dielectric-Liquid-Filled
Equipment
N/A
A drain valve shall be installed such that liquid may be drained
out to within 13 mm of the tank bottom.
N/A
4.24.4
Terminal Compartment
Not Dielectric-Liquid-Filled
Equipment
N/A
A separately enclosed terminal box or compartment shall be
provided to enclose field wiring connections.
N/A
4.24.5
Components
Not Dielectric-Liquid-Filled
Equipment
N/A
Internal wiring and other components inside the tank shall be of
a type suitable for oil immersion.
N/A
4.24.6
Lifting
Not Dielectric-Liquid-Filled
Equipment
N/A
Provision shall be made for lifting the PCE, and shall be such
that no permanent deformation of the tank or cover will occur
when thePCE is lifted. Lifting lugs shall have smooth, rounded
surfaces in locations of contact with lifting slings. Lifting lugs
shall be positioned such that the slings do not exert pressure
on any accessory.
N/A
4.24.7
Mounting
Not Dielectric-Liquid-Filled
Equipment
N/A
For wall- or pole-mounted PCE, the PCE tank and mounting
brackets shall comply with the mechanical loading test of
Clause 6.21.
N/A
4.24.8
Gaskets
Not Dielectric-Liquid-Filled
Equipment
N/A
Casket material shall not be affected by the insulating liquid.
Cover gaskets shall be retained in position so that they will not
be damaged when the cover is removed or replaced.
N/A
4.24.9
Dielectric Liquid
Not Dielectric-Liquid-Filled
Equipment
N/A
Insulating liquid used in, or recommended for use with,
equipment covered by this Standard shall conform to CSA
Standard CAN/CSA-C50, or the equivalent.
N/A
4.24.10
Emergency Pressure-Relief Device
Not Dielectric-Liquid-Filled
Equipment
N/A