User manual

Pre-Ride Checklist – SE3 Patroller
Perform the following checks on the SE-3 Patroller before each ride:
ProTIP: Copy and post this page near your SE-3 Patroller parking area – check  the
boxes off as you go down the list.
 Check tire pressure
Front – 22 psi (1.52 Bar; 152 kPa)
Rear – 25 psi (1.72 Bar; 172 kPa)
 Check for tire wear
Front – tire tread depth is less than 2 mm
Rear – 3.8 mm (or when the tread is flush with the tread wear indicators)
 Ensure there is no visible damage to the SE-3 Patroller or loose bodywork.
 Verify the brake levers are firm when squeezed and the brake fluid level is
above the “low” mark.
Right – Rear brake fluid reservoir
Left – Front brake fluid reservoir
 Ensure the Rider Detect Mat is intact, secure, and free of debris.