User manual

62
Tires and Wheels (cont.)
Replacing a Rear Tire/Wheel
Tools: Vehicle jack
Wheel nut key (included with the SE-3 Patroller)
19 mm or 21 mm socket wrench
Torque wrench
Rear Tire/Wheel Removal
1. Make sure the SE-3 Patroller is powered off and unplugged.
2. Apply the parking brake (p. 24).
3. Using the wheel nut key, loosen but do not remove the four Wheel
Nuts.
4. Place the vehicle jack under the back of the SE-3 Patroller skid
plate, close to the wheel being changed (Figure 50). Raise the SE-3
Patroller until the wheel is just off the ground.
WARNING
Do not lift both rear wheels off the ground. Two wheels must always
remain in contact with the ground to reduce the possibility of the SE-3
Patroller tipping over while it is on the jack.
5. Using the wheel nut key, remove all four Wheel Nuts.
6. Pull the wheel off the studs.
Figure 50: SE-3 Patroller Rear Lifting Points
Place jack here