User manual

Recalibrating the Battery Charge Level Display

There are two Battery Charge Level displays: one on the Battery Module itself

(the Battery Discharge Indicator), and one on the User Interface Display. These

displays may be inaccurate after long periods of storage or during initial use.

To recalibrate the displays:

1. Fully charge the Battery Module for 12 hours.

2. Discharge the Battery Module (through normal use of the SE-3) until

the bottom bar on the Battery Discharge Indicator is blinking or the

User Interface Display indicates 10% charge (Figure 44).

3. Leave the SE-3 Patroller in a safe, secure location, powered on, until

the Battery Module is fully depleted and the SE-3 powers down.

NOTE:

Depleting the Battery Module from the bottom bar to empty could

take several hours.

CAUTION

Do not leave the Battery Module completely empty for more than two

hours. Leaving the Battery Module empty could cause permanent

damage to the Battery Module.

4. Fully recharge the Battery Module for a minimum of 12 hours, after

which the Battery Charge Level Display will be recalibrated.

Figure 44: BDI Indicating 10% Charge Remaining