User manual

52
Battery Discharge Indicator (BDI) (cont.)
2. If the Battery Module is empty, Bring the SE-3 Patroller indoors
or someplace where the temperature is within the recommended
range (Table 4, p. 47).
3. Charge the SE-3 Patroller for 12 hours.
If the bottom LED continues to blink red while discharging (charger not
plugged in), contact Segway Technical Support.
Charging Failures
If a failure is detected during charging, all charging will stop and the BDI LEDs
will turn off. Note that the LEDs also turn off when the Battery Module is fully
charged. If the Battery Module fails to charge when it is low or empty, it may
need to be replaced. To order a replacement Battery Module, contact an
Authorized Segway Dealer or Distributor.
User Interface Battery Charge Level Gauge
The User Interface Display uses a grey battery icon to indicate the Battery
Module charge level (Figure 42). As the charge level depletes, the battery icon
"level" reduces. If the charge level drops below 15%, the color of the battery
icon changes to red, and "Low Battery" will display on the left hand side of
the User Interface (Figure 43). If the charge level is 0%, Empty Battery" will
display.
If the battery icon is red, do not attempt to ride the SE-3 Patroller. Instead,
charge the Battery Module.
99999.9 999.9OD TRIP
MPH 15
RND
RIDER PRESENT
Figure 42: Battery Charge Level at 75%
99999.9 999.9OD TRIP
MPH
8
RND
RIDER PRESENT
WARNING
LOW POWER
Figure 43: User Interface Low Battery Charge Level Warning