User manual
51
Info SE-3 Setup Operate Riding
Tips
Battery Maintain T-shoot Warn Contact
Index Schedule
Unplugging the SE-3 Patroller
When you are ready to operate the SE-3 Patroller, remove the Power Cord:
1. Disconnect the Power Cord from the Charge Port.
2. Disconnect the Power Cord from the grounded AC outlet.
3. Store the Power Cord.
Battery Discharge Indicator (BDI)
The Battery Discharge Indicator on the Battery Module illuminates when the
Battery Module is charging or in use (see Table 5). When charging, the lights
scroll from the bottom upward indicating the charge level. When the Battery
Module is fully charged the lights will turn off.
When in use the lights are solid, indicating the charge level. For example, the
seventh LED from the bottom would indicate the battery module is currently
at 70%. The fourth LED from the bottom would represent 40%, and so on
(Figure 41). When the Battery Module is less than 20% full, the last two lights
will flash.
The bottom-most light blinks red for warnings and faults. It may blink because
of over-voltage, under-voltage, or over-temperature conditions. The light may
also blink while the Battery Module is charging because of temporary over-
voltage conditions while balancing; this is normal. If you notice this light is
blinking while discharging (charger not plugged in), follow these steps:
1. Power down the SE-3 Patroller and allow time for the Battery Module
to cool.
Charge Level Indicator LEDs
Charging LEDs scroll bottom to top
Charging Complete All LEDs OFF
Discharge/normal use LEDs indicate charge level
Error Condition Bottom Red LED flashing
while discharging
Table 5: BDI LED Messaging
Figure 41: Battery Discharge Indicator (BDI)
Battery Module at 70% Battery Module at 40%